Camera Strap Cover: Tutorial

Fitted Camera Strap Cover Tutorial

STEP ONE:

Fold your camera strap in half, lay it over your fabric so that the fold of your strap is ON THE FOLD of the fabric. I should have got a better picture of that.
Outline! I used a sharpie so you could see it a little better.

 STEP TWO:

From your outline, measure out half of an inch and draw that line. Cut around the second line you made. 

  STEP THREE:

Cut two more pieces: One about 1 1/2 inch longer than half of the strap cover and the second one 1/2 longer than half of the strap cover.

 STEP FOUR:

Fold the ends about 1/3 of an inch over and sew.  Do the same on BOTH ends of EVERY piece.

STEP FIVE:

Put your pieces right sides together so that the longer back piece is under the shorter one

STEP SIX:

Sew down each long side, and then turn it right side out! 

I put a safety pin in the end to make it easier to pull through :)

STEP SEVEN:

Put your strap in, put it back on your camera, and enjoy!!